Stiga MULTICLIP 46S User Manual
  1. Manuals
  2. Brands
  3. Stiga Manuals
  4. Lawn Mower
  5. MULTICLIP 46S
  6. User manual

Stiga MULTICLIP 46S User Manual

Stiga lawn mower user manual
Hide thumbs
Table of Contents

Advertisement

Quick Links

D
DEUTSCH
Multiclip
8211-0203-08

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MULTICLIP 46S and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Stiga MULTICLIP 46S

Summary of Contents for Stiga MULTICLIP 46S

  • Page 1 DEUTSCH Multiclip 8211-0203-08...
  • Page 2 5. Multiclip 46 SE 0,15 l. 7. Briggs & Stratton ES 45 SVENSKA 6. Briggs & Stratton LS 45 / LS 38 8. Honda FULL FULL...
  • Page 3 9. Tecumseh 11. Multiclip 46 SE 13. Briggs & Stratton LS 45 / LS 38 15. Honda SVENSKA 10. Multiclip 46 S 12. Briggs & Stratton ES 45 14. Tecumseh...
  • Page 4 21. Briggs & Stratton LS 45 / LS 38 23. Honda SVENSKA 22. Briggs & Stratton ES 45...
  • Page 5 24. Tecumseh 40 Nm 40 Nm SVENSKA Briggs & Stratton : 0,75 mm 0,75 mm Tecumseh: 0,6 mm Honda: 0,7-0,8 mm...

  • Page 6: Using The Mower

    SYMBOLS The following symbols are displayed on the ma- chine in order to remind you about the safety pre- cautions and attention necessary when using the machine. The symbols mean: Warning! Read the Instruction Book and Safety Manual before using the machine. Warning! Keep spectators away.

  • Page 7: Starting The Engine (Honda)

    FILL UP THE PETROL TANK Fill with petrol before starting the mo- tor. Never remove the filler cap or fill with petrol while the motor is running or still warm. Never fill the fuel tank completely full but allow a little room for the petrol to expand.

  • Page 8: Stopping The Engine

    STOPPING THE ENGINE The motor may be very warm immedi- ately after it is shut off. Do not touch the silencer, cylinder or cooling flanges as it can cause burns and injury. 1. Release Start/Stop brace G to stop the engine (fig.

  • Page 9: Cooling System

    The inside of the drive wheels should be cleaned once a season. To clean a wheel, remove the hub- cap, screw, washer, and wheels. Brush or blow the gear and the gear ring on the wheel to clean them from grass and dirt (fig. 19). Remount the wheel. COOLING SYSTEM Before use, the engine's cooling system should be cleaned.

  • Page 10: Adjusting The Clutch Cable

    Always use genuine spare parts. To replace the blade, slacken the screw K. Fit the new blade so that the stamped STIGA logotype is turned facing the blade attachment (and not facing the grass). Refit the washer and screw. Tighten the screw fully to a torque of 40 Nm (fig.

  • Page 11: Winter Storage

    Once the blade has been sharpened, it must then be balanced so as to avoid vi- bration damage (fig. 28). STORAGE WINTER STORAGE Empty the fuel tank. Start the engine and let it run until it stops. The same petrol must not remain in the tank for more than one month.

This manual is also suitable for:

Multiclip 46 seMulticlip 46 s

Table of Contents

Save PDF