Page 1
BRUKSANVISNING KÄYTTÖOHJEET BRUGSANVISNING BRUKSANVISNING GEBRAUCHSANWEISUNG INSTRUCTIONS FOR USE MODE D’EMPLOI GEBRUIKSAANWIJZING ISTRUZIONI PER L’USO INSTRUCCIONES DE USO INSTRUÇõES DE UTILIZAÇÃO INSTRUKCJA OBS£UGI »HC“P”K÷»fl œOÀ‹«Œ¬¿“EÀfl NÁVOD K POU®ITÍ HASZNÁLATI UTASÍTÁS NAVODILA ZA UPORABO S T I G A S i l e x 5 00 - G S i l ex 5 0 0R - G SV ...
1 SYMBOLS The following symbols can be found on the rotary cultivator/in these instructions. These will provide a reminder of the care and attention that is required during operation. If any symbol is missing, has been damaged or is illegible, it must immediately be replaced with a new one.
• Wear tightly fitting clothes and heavy-duty shoes which completely cover the feet. • The tank should only be half full when operat- ing on slopes. Petrol can leak out. • The engine must be stopped in the following circumstances: •...
Page 6
3.6 Cable for reverse control Only applies to 500R-G. The cable is marked R. 1. Hook the cable in the reverse control (1:C) and insert the cable in the gap in the cable housing’s mounting on the left handle. 2. Adjust the cable sleeve if necessary. 3.7 Drive cable 1.
4.11Cutting disc (1:K) Nobody must be close to the dangerous cutting discs during operation. The cutting discs are on respective rotor axles and are designed to border the working area and facilitate control of the machine. 4.12 Choke The choke must never be activated dur- ing operation.
5.2.1 Starting the engine from cold 1. Put the choke in position “CHOKE”. See the accompanying engine manual. 2. Set the throttle (1:A) in the “START” position. 3. Hold the handle with one hand and slowly pull the starter handle with the other hand. See the accompanying engine manual.
3. Wash the pre-filter (foam rubber) in liquid de- tergent and water. Then carefully twist the filter out and allow to dry. 4. When the pre-filter is dry, reinstall the filter in reverse order. The filters must be replaced if very dirty or defec- tive.