Required Exterior Clearances - State Water Heaters SANDBLASTER SBD30 150 Service Handbook

SBN71-120 thru 85-390, SBD30-150/199 TANK TYPE COMMERCIAL

REQUIRED EXTERIOR CLEARANCES

The illustration below shows the required clearances for venting units using natural draft
venting.
The vent must extend at least 3 feet above the highest point where it passes through a roof of
a building and at least 2 feet higher than any portion of a building within a horizontal distance
of 10 feet (for vents of 12 inches in diameter or less).
References: NFPA 54 2006; ANSI Z 223.1 SEC 12.6.2 and Sec12.7.2 may allow reduction to
8 feet with a "listed vent cap."
"
Copyright by the American Gas Association. Used by permission of the copyright holder"
S a t e t W t a r e H e a e t
A s h a l n d C t i , y T e n n
GAS WATER HEATER SERVICE HANDBOOK
s r
e s s e e © 2 0 0 7
6 T e
.
c h n c i l a T a r n i n i g D e p a t r m e t n