Battery Installation
WARNING!
Replace the battery immediately if it is damaged.
Press The cover button
Slide the cover
Fig.2
backward
Fig.4
Clockise tightening
CHARGE THE BATTERY:
1. Please take battery out Fig.2 - 5 reversed, connect charge
socket and Battery charge plug to charge the battery;
2. The light on adaptor is red when charging, it is green when
battery is fully charged, in about 1.5~2 hours;
3. Please make sure
Charge socket
dry and clean when charge the battery;
4. Please charge in a dry and ventilated environment.
Adaptor
plug
Charge
socket
Fig.4
Aim connector at
Fig.3
battery plug-in and plug
Slide the cover
Fig.5
forward till closed
and
are
Battery charge plug
Battery charge plug
Fig.5
6
Getting started
Unlock the Safety Master Lock
Press both buttons to start; Grab tight underwater
Change to Hi Speed
LED battery status indicator
(operates when Master Switch is on)
Your Seascooter has a Battery Status Indicator (see Fig. 1 "Parts
Diagram" - part 6), which can be seen through the LED Window
located in the Handle. When the battery is full, 4 LEDs are on. When
3 LEDs are on, 3/4 of power remains. When 2 LEDs are on, 1/2 of
power remains. When 4 LED is blinking in red color, the seascooter
will switch to low speed and could only run for approx. 3 minutes.
Fig.6
Fig.7
Fig.8
7