Advertisement
There are 2 ways to set the slave module. It is Manual setting and Automatic setting.
First of all, Manual setting is as shown below.
Click the Slave setting icon (It is indicated red circle), the screen is changed as shown below [Figure
10.1.4]. If there is not a slave module to register in dotted line as shown below, GSD file should be copied
in file directory as shown below [Figure 10.1.5]
Station address 1 of slave module is selected as shown above [Figure 10.1.4]. After station address set to
1 as shown below, click 'OK'. Slave module setting is as shown below. Double-click the applicable module,
Slave configuration is displayed. In the slave configuration, it displays the status of slave module GSD file
applied and status of Input/Output appended currently.
3
Pnet I/F Module 2MLL-PSRA, 2MLL-PMEA, 2MLL-PMEB User's Guide
[Figure 10.1.4 Slave module setting (Manual setting)
[Figure 10.1.5] GSD file directory
Honeywell
Chapter 10 Program Example
January 2019
R220
Advertisement
