Download
Share
Print this page
Stanton Professional Valve DJ Mixer VRM-10 Owner's Manual
  1. Manuals
  2. Brands
  3. Stanton Manuals
  4. Music Mixer
  5. VRM-10
  6. Owner's manual

Stanton Professional Valve DJ Mixer VRM-10 Owner's Manual

Professional valve dj mixer
Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Quick Links

Download this manual
VRM-10
Professional Valve DJ mixer
OWNER'S M A N U A L

Advertisement

loading
Need help?

Need help?

Do you have a question about the Professional Valve DJ Mixer VRM-10 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Stanton Professional Valve DJ Mixer VRM-10

Summary of Contents for Stanton Professional Valve DJ Mixer VRM-10

  • Page 1 VRM-10 Professional Valve DJ mixer OWNER’S M A N U A L...
  • Page 2 EFFECT RETURN When using an external effects processor (such as the Stanton DJF1 professional DJ filter) you must connect the EFFECT SEND to the input of your processor and the EFFECT RETURN to the output of your effects unit. The input and output volumes can be at a maximum of 0dBu.
  • Page 3 BOOTH The output value of the BOOTH is set at 0dBu. It can be adjusted via the control knob BOOTH (49) NOTE : BOOTH output is not affected by any balance/pan setting (50). MASTER 2 The output MASTER 2 is identical to MASTER 1. It has an output impedance of +6dBu, which can be adjusted by the MASTER 2 control.
  • Page 4 MICROPHONE CHANNEL DJ MIC 2 DJ MIC 1 Both mic inputs can be used as symmetrical or non- sym- metrical (balanced or non-balanced) channels with either XLR or 1/4” jacks, with the provided combo connectors THE XLR jack are set as follows: +SIGNAL -SIGNAL THE 1/4”...
  • Page 5 effect individually. The middle position of this control will have the value of the individual selected effect preset indi- cated in the diagram above. DEPTH With this control you can adjust the intensity of the LFO SELECT With this switch you can choose the channel on which the effect should work.
  • Page 6 35/36 CROSSFADE LED’s The LED’s located left and right of the crossfader indicate, which input channel lies on which side of the crossfader according to the crossfader assign switch (22). CROSSFADE CURVE With this control you adjust the crossfade curve. When the knob is set completely to the left, the crossfader curve is set to a sharp on/off cut on both sides.

  • Page 7: Warranty

    FOR THE WARRANTY TO BE VALID, PLEASE COMPLETE THE ONLINE WARRANTY REGISTRATION FORM FOUND AT Stanton Magnetics, LLC, 2821 Evans Street • Hollywood, FL 33020 (954) 929-8999 Fax: (954) 929-0333 (off), the master signal is set to post-filter. EFFECT By pressing the EFFECT switch you can pre-listen to the internal effect signal.

  • Page 8: Block Diagram

    BLOCK DIAGRAM...