Stabila HL-100 Operating Instructions Manual

Stabila HL-100 Operating Instructions Manual

Hole locator

Advertisement

Quick Links

Hole Locator HL-100
USA
Operating instructions

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HL-100 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Stabila HL-100

  • Page 1 Hole Locator HL-100 Operating instructions...
  • Page 2: Main Applications

    Operating manual: Should you have additional questions concerning this product’ s operation and use or care and maintance, please call our Customer Service number: 1.800.869.7460 U.S. and Canada 1. Main applications: The HL 100 hole locator is an easy-to-use point laser for aligning a series of holes in a straight line.
  • Page 3: Main Components

    2. Main components Laser beam emission aperture ON/OFF switch Vertical setting dial (up/down) Horizontal setting dial (left/right) Small locking nut for holes from over 7/8” to 3” in diameter (20mm-75mm) Large locking nut for holes from 3 1/4” to 4 3/4”in diameter (80mm-120mm) Adapter plate for holes over 3”...
  • Page 4 3. Method of operation: 3.1. Installation in joists / studs / panels I. Hole diameter ( small / large ) : The HL 100 can be directly installed in holes from ” to 3” in diameter using the yellow locking nut (5). The large black locking nut (6) and the adapter plate (7) are used for larger holes of 3 ”...
  • Page 5 II. Aligning the laser dot horizontally (left - right): Mark the horizontal position on the second joist / stud. (No need to measure the vertical position). Turn on the laser(2). Dial the laser beam onto the mark by using the horizontal setting dial (4). ATTENTION : To ensure that the HL 100 is set up to point in the right direction, it is important that the lay out and drilling of the first joist/stud , as well as the...
  • Page 6 IV. Continue to drill The laser is now correctly aligned. Drill the second hole by setting the drill bit directly on the center of the laser dot location. Clear the debris from the hole, if necessary, to allow laser beam to pass through.
  • Page 7: Checking The Calibration

    Warning: This is a class IIIa laser. Do not look directly into the laser beam ! Keep this product away from children ! The goggles supplied with these units are not safety goggles. They enable you to see the laser beam more clearly in bright light conditions.
  • Page 8: Technical Data

    Stabila provides a guarantee against defects in material and workmanship for a period of 12 months from date of purchase. Manufactoring defects will be eliminated at Stabila's own discretion either by repairing or replacing the unit. Stabila accepts no other claims.
  • Page 9 STABILA Inc. 332 Industrial Drive South Elgin , IL 60177 1.800.869.7460 www.stabila.com...

Table of Contents