Subscribe to Our Youtube Channel
Related Manuals for Spin Master Goyo Racer
Summary of Contents for Spin Master Goyo Racer
- Page 2 Page 3: Getting Started. Page 8: Using As A Regular Page 9: Racing – Beginner’s Mode. Page 11: Racing – Standard Mode. Page 14: For Best Performance. Page 16: Changing Your Tires And Mags. Page 17: Tricks. Page 20: Accessories. Yoyo.
- Page 3 GOYO OVERVIEW Square Button Screw Trigger Round Button C-Clip Screw...
- Page 4 STEP 1: UNLOCKING GOYO Hold down SQUARE button and flick TRIGGER up. The ROUND button will pop out.
- Page 5 STEP 2: ATTACHING STRING Lower C-CLIP string into GOYO until it rests on centre axle. Press ROUND button. Your string should now be securely attached to the GOYO.
-
Page 6: Step 3: String Setup
STEP 3: STRING SETUP Cut string to the correct height by letting the GOYO unwind until it touches the ground and cut at WAIST height. Tie a loop in the string then create a slipknot to wrap around your finger. - Page 7 STEP 4: WINDING STRING For correct winding, use your THUMB to pinch the string to the side of the GOYO. Wind string TIGHTLY around twice and release thumb as you continue winding.
- Page 8 TO USE AS A REGULAR YOYO After following the steps in “Getting Started”, flick the TRIGGER DOWN to use as a regular yoyo. Ensure ROUND Button is pressed in before each throw.
- Page 9 TO RACE IN BEGINNER’S MODE When string is attached and wound up, hold down SQUARE button and flick TRIGGER up. The ROUND button will pop up. If the ROUND button is up, your GOYO will not sleep, but roll directly off the string. Ensure you throw your GOYO with a fast, overhand motion downwards towards the ground.
- Page 11 STEP 1: SETUP AND THROW Flick the TRIGGER UP and you’re ready to race. To race, GOYO has to be thrown with a sharp OVER- HAND fling.
- Page 12 STEP 2: SLEEPING AND RELEASE Once your GOYO is spinning on the end of the string (sleeping), gently lower. When it touches the ground it will release from the string and race away.
- Page 13 STEP 3: RESETTING YOUR GOYO To reset your GOYO, follow steps 1, 2 and 4 in the “Getting Started” section. STEP 2 STEP 1 STEP 4...
-
Page 14: For Best Performance
FOR BEST PERFORMANCE Race your GOYO on a HARD surface like concrete, floorboards, tiles, etc. TO ENSURE GOYO RACES OFF THE STRING Always throw the GOYO down towards the ground with a sharp, hard and fast overhand motion. - Page 15 CAUTION Ensure ROUND Button is pressed in before each throw. When racing: Use GOYO outdoors in safe open areas away from traffic and parked cars. Pavement use not recommended. Do not chase your GOYO racer onto the road.
- Page 16 Do not leave GOYO lying around in 2 parts. Always assemble when not in use. Line up guide holes with guide pins Using a small screwdriver, unscrew screws to change tires and mags.
- Page 17 DOWN THE STRAIGHT With the spare hubcaps set up check points in a straight line. Stand at one end and see how close to each check point you can get. LIFTOFF Set up 2 chairs about 15 inches apart. Tie a string from one chair to the other.
- Page 18 QUARTER MILE Make a start line, then make a finish line about 19 feet away using spare hubcaps. See who gets to the finish line first! BULLSEYE Pick a target 19 feet away from you. Take it in turns to see who can get closest to the target.
- Page 19 CRASH AND BASH Set up some pins to knock down (eg. empty cans). The aim is to knock over as many pins as possible. Start from 3 feet away and when you get better, move further backwards. OUTRUN Start at the same place and "Ready, set, go!", see who can race the furthest away.
Need help?
Do you have a question about the Goyo Racer and is the answer not in the manual?
Questions and answers