WARNING To prevent fire or shock hazard, do not expose this appliance to rain or moisture. CAUTION TO PREVENT ELECTRONIC SHOCK, DO NOT USE THIS (POLARIZED) PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE PLUG CAN BE FULLY INSERTED WITHOUT EXPOSING ANY PARTS OF THE BLADES.
SAFETY INSTRUCTIONS This product was designed and manufactured to meet strict quality and safety standards. There are, however, some installation and operation precautions which you should be particularly aware of. 1. Read Instructions — All the safety and operating instructions should be read before the appli- ance is operated.
LOCATION OF CONTROLS AND INDICATORS 1. Pause Button 2. Stop / Eject Button 3. Fast Forward Button 4. Fast Rewind Button 5. Play Button 6. Record Button 7. CD Door Open 8. Band Selector 9. Tuning Dial Pointer 10. CD. F. Skip Button 11.
POWER SUPPLY Battery supply • Open the battery compartment and insert as shown 8 batteries, type R14, UM2 or C-cells. • Remove the batteries if exhausted or if they will not be used again for a long period. * The battery supply is switched off when the set is connected to the mains. •...
COMPACT DISC OPERATION Inserting a CD • Set the Function switch to CD. • To open the CD compartment, lift the CD door on the edge marked OPEN/CLOSE. • Insert the AUDIO CD, printed side facing up. • Close the cover. * The CD-player scans the contents list of the CD.
HANDLING COMPACT DISCS This unit is designed to play only compact discs bearing the identification logo below. Other discs may not conform to the CD standard and may not play properly. • Dirty, scratched or warped disc may cause skipping or noise. •...
CASSETTE DECK OPERATION Cassette playback • Set the Function switch to TAPE. • Press STOP/EJECT to open the cassette holder. • Insert a recorded cassette. • Adjust the sound using the VOLUME and DBBS controls. • Press PLAY and playback will start. * Playback stops when the tape in the deck reaches the end.
Page 9
Recording from the radio • Insert a blank or pre-recorded tape into the cassette compartment. • Set the Function selector to RADIO. • Select the wave band using the BAND SELECT switch. • Tune to desired radio station using the TUNING control. •...
PERIODIC MAINTENANCE EXTERNAL CARE Periodically wipe the cabinet with a soft cloth damped in diluted soapy solution, then wipe with a dry cloth. Do not use harsh cleansing chemicals, they may damager or discolor the cabinet finish. Do not allow liquids or foreign objects to enter the CD compartment.
SPECIFICATION Frequency range Antennas Frequency response Speaker Power output Power requriements Power consumption Dimensions Weight Accessory supplied DESIGN AND SPECIFICATION ARE SUBJECT TO CHANGE WITHOUT NOTICE. FM: 87 -108 MHz AM: 530 - 1710 KHz FM: Telescopic antenna AM: Built-in ferrite bar 100-8,000Hz 3"...
Need help?
Do you have a question about the 1776 and is the answer not in the manual?
Questions and answers