ROLL WING
GYRO FORCE™
Gyro Force™ requires one 9.6-V rechargeable and one 9-V battery to run (Included).
9.? VOLT
1 -
Locate the battery
door on the bottom
of the vehicle.
Unscrew to release
2 -
the battery door as
shown.
3 -
Place the batteries
in the tray according
to the polarity
markings as shown.
INSTALLING CONTROLLER
9-VOLT BATTERY
1 -
Using a Phillips
screwdriver, undo the
hold-down screw and
remove the battery
compartment door.
GETTING STARTED
1 -
Turn the "ON-OFF"
switch to the "ON"
position.
2 -
Use Controller
to move vehicle
forwards or
backwards.
Note: If you press right or left while holding the Turbo
button, Gyro Force™ will roll over and perform stunts.
TM
SPOILER
BATTERY
DOOR
WHEELS
BATTERY INSTALLATION
INSTALLING BATTERIES IN THE GYRO FORCE™
4 -
Connect the battery
wire to the car wire
as shown.
Replace the battery
5 -
door and tighten the
screw back into
place.
2 -
Place the 9-V
battery in the battery
compartment, making
sure to follow the
correct + and - polarity
markings.
3 -
The vehicle steers like a
skateboard. By positioning either
right or left, the vehicle will turn
right and then left/left and then
right. To steer, release the turn
button once the vehicle is pointing
in the direction desired.
Before taking Gyro Force™ back to the
retailer, call our friendly RC technicians at:
1-800-622-8339.
GYRO
STORAGE: The Gyro Force™ should be
stored indoors in the foam tray enclosed in
the box after each use.
CONTROLLER
FORWARD/
REVERSE
FRONT
BUMPER
Turn
Vehicle
Over
1
Battery
Compartment Door
3 -
Replace the battery
compartment door
and refasten the
hold-down screw.
IMPORTANT! PROBLEMS?
GYRO
FORWARD/
REVERSE
Battery
Compartment
2
Door
9.6-V
3
Battery
Battery
Compartment
Battery
1
Compartment
Door
2
9-V
Battery
3
Battery
Compartment
TURBO