AEG IAE64843FB User Manual page 12

12 www.aeg.com
To deactivate the function, touch
cooking zones operate independently.
6.9 Timer
Count Down Timer
+STOP
Use this function to specify how long a
cooking zone should operate during a
single cooking session.
You can set the function for each
cooking zone separately.
1. Set the heat setting for the
appropriate cooking zone first and
then set the function.
2. Touch
The timer menu window appears on the
display.
3. Check
The symbols change to
4. Slide your finger to the left or right to
select the desired time (e.g. hours
and/or minutes).
5. Touch OK to confirm your selection.
You can also choose
selection.
When the time comes to an end, a signal
sounds and
the signal.
To deactivate the function set the heat
setting to 0. Alternatively, touch
the left of the timer value, touch
.
to activate the function.
.
+STOP
to cancel your
blinks. Touch to stop
+STOP
to it and confirm your choice when a
pop-up window appears.
Minute Minder
You can use this function when the hob is
activated but the cooking zones do not
operate.
The function has no effect on the
operation of the cooking zones.
1. Select any cooking zone.
The relevant slider appears on the
display.
2. Touch
The timer menu window appears on the
display.
3. Slide your finger to the left or right to
select the desired time (e.g. hours
. The
and minutes).
4. Touch OK to confirm your selection.
You can also choose
selection.
When the time comes to an end, a signal
sounds and
the signal.
To deactivate the function touch
the left of the timer value, touch
to it and confirm your choice when a
pop-up window appears.
Stopwatch
The function automatically starts
counting immediately after you activate a
cooking zone. You can use this function
to monitor how long it operates.
1. Touch
2. Scroll the Menu to select Settings >
Stopwatch.
3. Touch the switch to turn the function
on / off.
To leave the Menu touch
side of the display, outside of the pop-up
window. To navigate through the Menu
use or .
The function does not stop when you lift
the pot. To reset the function and start it
again manually touch
to
from the pop-up window. The function
next
.
to cancel your
flashes. Touch
to access the Menu.
or the right
, select Reset
to stop
to
next