Page 4
Harper Industries or at the manufacturing plant in Harper, KS. A part will be replaced after inspection discloses it to have been defective. This warranty does not apply to defects caused by damage or unreasonable use (includ- ing failure to provide reasonable and necessary maintenance, or by performing functions without genuine Harper ATM accessories) while in the possession of the consumer.
Table of Contents Introduction OPERATOR SECTION The objective of Harper Industries in design- To the Owner or Operator..........ing the ATM 72 LC was to create a mowing Warranty Statement............machine that could function safely and com- Table of Contents.............. Introduction...............
Crown AW46; ISO 46 Hydraulic Oil NOTE: Following publication of this manual, certain changes in standard equipment and/or options may have occurred which would not be included in these pages. Your Harper dealer is the best source for up-to-date information.
Park Brake – set park brake when unit is not Leveling Lockout Light – turns on when the in use or is parked on an incline. Make sure auto level funtion has been locked out. park brake is disengaged before operation. ATM 72 LC...
Page 9
SAFETY WARNING! Do not leave ATM 72LC unattended, or attempt any service or inspection unless the machine has come to a complete stop and the engine has been shut off. ATM 72 LC...
If you replace parts that have such • Keep the equipment in good operating decals attached to them, make sure condition. the decals are replaced with current versions, and are on the replacement parts before the machine is operated again. ATM 72 LC...
• Make sure that all bearings or hinging bounce. parts are greased and or oiled prop- • The park break is applied when the erly. operator is out of the seat. ATM 72 LC...
Keep the hydraulic oil just above the • Pennzoil AWX MV 46 lower sight glass at all times. • Shell Tellus T 46 • Fill reservoir through the fill location on • Texaco Rando HDZ 46 top of the reservoir. ATM 72 LC...
Give 2 to 3 shots of grease after every 10 hours of use. Air Intake • Make sure intake is always free of debris. • When engine is turned off, remove the wing bolt. • Replace the air filter according to the Maintenance Schedule. ATM 72 LC...
Hot Coolant and steam from the radiator can cause severe burns. Never open the • Filled with SAE10W-30 from the radiator cap of a hot engine. factory, 6.0 L capacity, and change after the first 50 hours. ATM 72 LC...
It can be accessed from below the machine. Relay Panel • Block deck up before working under the deck. • Located under the hood behind the dash of the mower. ATM 72 LC...
These tools finished moving unit. Failure to close can be found inside the toolbox. valve tightly will result in full or partial 3. Tighten the nut until the motor shaft turns loss of power. freely. ATM 72 LC...
The seat the machine that are located at the front and belt is retractable rear of each side of the machine, and they are and will lock up accompanied by the following decal: on impact or accident. ATM 72 LC...
(see pg. 5 for location). • Lower the deck all the way down using the switch on the dash. • The outer deck height is controlled by the arm linkage attached to the stabilizer arm. ATM 72 LC...
Check fuel level o Visually inspect the fan belt, bolts, fittings, hoses, or any damaged parts o Check radiator and oil cooler o Check engine screens o Check Air cleaner intake o Check engine coolant level ATM 72 LC...
Page 25
Be sure to disengage the Mower Switch before raising deck wings. • Lights Switch - Use the lights as needed to avoid obstacles that could damage the machine or harm the operator in any way. ATM 72 LC...
Need help?
Do you have a question about the ATM 72 LC and is the answer not in the manual?
Questions and answers