Resetting Trip Or Driver Meter To Zero - Siemens VDO EDM eco Release II Operating Instructions Manual

EDM eco
Operating instructions

Resetting trip or driver meter to zero

TU00-1404-0311020
1 Press the key until the currently displayed driver meter number flashes on
the right hand side of the screen.
2 Select the required driver meter using the
Hold down either key: The unit counts up or down in steps of 10.
3 Confirm the selected driver meter using the
Depending on the settings you may be asked to enter the driver PIN number
for the relevant driver meter (-> 24).
If the padlock appears on the display a driver meter is protected at least by a
PIN number.
1 Select the required meter (trip or driver meter, -> 22), that you want to reset to
zero.
Depending on the settings you may be asked to enter the relevant driver PIN
number before accepting a driver meter (-> 24).
2 Press the key until a beep is audible.
If the system PIN has been activated, this PIN must be entered before the
drivers meters can be reset (-> 32).
© Siemens VDO Trading GmbH
Trip and driver meters
keys.
key.
23