Selecting
the Color
∆
for
TEMP
Extra Configuration for the CO
Selecting
the Unit for
the CO
2
Measure-
ment
Selecting
the Color
for CO
2
Selecting
Sampling
Method for
EtCO
(and
2
ImCO
for
2
the Side-
stream
Method)
Selecting
ImCO
On/
2
Off
In ∆TEMP setup (see "Selecting the D TEMP Setup" on page 240):
Step 1. Select Color. This defines the color for the ∆TEMP numeric.
Step 2. Select the color.
In CO
setup (see "Selecting the CO
2
Step 1. Select Unit.
Step 2. Select either mmHg or kPa.
In CO
setup (see "Selecting the CO
2
Step 1. Select Color. This defines the color for the CO
Step 2. Select the color.
In CO
setup (see "Selecting the CO
2
Step 1. Select Max Hold.If Max Hold is on, the largest measured value out
of the selected time period is displayed.
Step 2. Select the time period
off
The breath to breath value is displayed
10 sec
The largest measured value from the last 10 seconds is displayed.
20 sec
The largest measured value from the last 20 seconds is displayed.
In CO
setup (see "Selecting the CO
2
Step 1. Select ImCO
2
Step 2. Select On or Off to switch the ImCO
Extra Configuration for the CO
Measurement
2
Setup" on page 249):
2
Setup" on page 249):
2
Setup" on page 249):
2
Setup" on page 249):
2
.
Measurement
2
wave and numeric.
2
measurement on or off.
2
Configuration
365
Comments to this Manuals
Latest comments: