Soundstream SPL 55 Owner's Manual
Soundstream SPL 55 Owner's Manual

Soundstream SPL 55 Owner's Manual

2 ohm nominal coaxial speaker

Advertisement

2 Ohm Nominal
Coaxial Speaker
OWNER'S MANUAL
55.pub
page 1
1
Friday, September 10, 1999 21:03

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SPL 55 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Soundstream SPL 55

  • Page 1 2 Ohm Nominal Coaxial Speaker OWNER’S MANUAL 55.pub page 1 Friday, September 10, 1999 21:03...
  • Page 2 Before beginning your installation, please check to see that the number of parts contained in your box match the list below: CONNECTOR Hardware PARTS LIST 8 each - 1” #8 sheet metal screws (for mounting SPL 55) Connectors 4 each - ” tab female Gold insulated slip-on connectors 55.pub...
  • Page 3 2 Ohm Nominal System Impedance The 2 Ohm impedance design of the SPL 55 system provides an overall 3 dB increase in output compared to a 4 Ohm design. Effectively a doubling of Sound Pressure Level -- with the same...
  • Page 4 The first step in a successful installation is LOCATION thorough planning. Choose the location for your speaker components carefully. MOUNTING suggestions to ensure proper imaging and the best performance: Choose a location that offers the least obstruction of sound to your ears. Always check behind the chosen mounting locations to make sure that there are no obstructions (e.g., trunk springs, gas tank, window...
  • Page 5 The SPL 55 can be mounted on the front or rear of INSTALLING a panel; gaskets are provided for both options. The THE SPL 55 bolt hole configuration will fit a variety of American, Asian and European OEM patterns making it ideal for direct placement.
  • Page 6 WIRING SPL 55 Wiring Diagram The figure below shows wiring for the SPL 55 speaker. It is important to make sure that all connections are in phase; that is positive (+) is connected to positive (+), and negative (-) is connected to negative (-) since an out-of-phase connection will cause a dislocated image and low bass output.
  • Page 7: Specifications

    SPECIFICATIONS SPL 55 Specifications Frequency Response Sensitivity Continuous Power Handling Peak Program Power Handling Nominal Impedance Crossover Slope Rate Metal Dome Tweeter Frequency Response Sensitivity Nominal Impedance Nominal Tweeter Diameter Dimensions Nominal Driver Diameter Mounting Cut-Out Diameter Mounting Depth 55.pub page 7 70 Hz - 20,000 Hz ±3dB...
  • Page 8 (Rev A, 1/3/97) 120 Blue Ravine Road Folsom California 95630 USA tel 916.351.1288 fax 916.351.0414 55.pub Friday, September 10, 1999 21:03 page 8...

Table of Contents