Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for SoundCraft Five Monitor Series
Summary of Contents for SoundCraft Five Monitor Series
- Page 1 FIVE Monitor Contents...
- Page 2 Information in this manual is subject to change without notice and does not repre- sent a commitment on the part of the vendor. Soundcraft shall not be liable for loss or damage whatsoever arising from the use of information or any error con- tained in this manual.
-
Page 3: Functional Description
FIVE Monitor Contents FIVE M M onitor Contents 1. Introduction Introduction Warranty 2. Installation Dimensions Precautions and Safety Instructions Mains Installation Connections Block Diagrams 24-bus Mono Input Module 32-bus Mono Input Module 24-bus Stereo Input Module 32-bus Stereo Input Module 32-bus Output Module Master Module EQ Output Module... - Page 4 FIVE Monitor Contents...
- Page 26 EQ Output 3.10 FIVE Monitor Block Diagrams...
- Page 45 FIVE Monitor Functional Description MUTE M M ASTERS MUTE A A LL O O UTPUTS The MUTE ALL OUTPUTS switch will MUTE every Group and Matrix Output on the console (useful as either a ‘panic’ or ‘desk unattended’ switch). This switch is covered to prevent accidental triggering.
- Page 46 4.20 BSS V V ARICURVE™ R R EMOTE CONTROL FIVE Monitor may be inserted into the MIDI loop of a BSS FPC-900 Varicurve™ Remote Control and Slave system (see diagram below.) When so connected, pressing a SOLO on an Output of the FIVE Monitor will cause the necessary MIDI command to be sent to the Remote unit to SELECT the EQ associated with that Output, thus automatically bringing the EQ for the SOLO’ed channel onto the remote for editing.
- Page 47 FIVE Monitor Functional Description LOGIC I I N / / L L OGIC O O UT Rear Panel EDAC connectors are provided to link the logic systems of one FIVE Monitor with a second console in a Master/Slave configuration. See Chapter 2, Installation, for connection details.
- Page 48 4.22 FIVE Monitor Functional Description...