Table of Contents
Advertisement
CAUTION
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
Important notice on the batteries for the Hitachi
cordless power tools
Please always use one of our designated genuine
batteries. We cannot guarantee the safety and
performance of our cordless power tool when used with
batteries other than these designated by us, or when
the battery is disassembled and modifi ed (such as
disassembly and replacement of cells or other internal
parts).
TROUBLESHOOTING
Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your
dealer or the Hitachi Authorized Service Center.
1. Power tool
Symptom
Tool doesn't run
Tool suddenly stopped
Low blowing power
Battery cannot be installed
Possible cause
No remaining battery power
Battery isn't fully installed.
Tool was overburdened
The battery is overheated.
Foreign matter is blocking the intake vent.
Foreign matter is lodged in the blast port or
in the suction port.
Battery power is low. The battery is
completely depleted.
Attempting to install a battery other than that
specifi ed for the tool.
NOTE
Due to HITACHI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
Charge the battery.
Push the battery in until you hear a click.
Get rid of the problem causing the
overburden.
Let the battery cool down.
Remove any foreign matter.
Remove any foreign matter.
Charge the battery.
Please install a multi volt type battery.
13
Remedy
Advertisement
Table of Contents
