Table of Contents
Advertisement
Quick Links
293 Wright St., Delavan, WI 53115
phone:
1-800-642-5930
Fax:
1-800-426-9446
Web site:
jungpumpen-us.com
©2011
InstallatIon and operator's Manual
Submersible Solids Handling Pump
Installation/Operation/Parts
For further operating, installation,
or maintenance assistance:
Call 1-800-642-5930
JP912 (1/21/11)
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Jung Pumpen V1D-01
Summary of Contents for Jung Pumpen V1D-01
- Page 1 InstallatIon and operator’s Manual Submersible Solids Handling Pump 293 Wright St., Delavan, WI 53115 phone: 1-800-642-5930 Fax: 1-800-426-9446 Web site: jungpumpen-us.com Installation/Operation/Parts For further operating, installation, or maintenance assistance: Call 1-800-642-5930 ©2011 JP912 (1/21/11)
-
Page 2: Table Of Contents
(interruption of power to the pump, large solids in application. the sump, flooding that exceeds the pump’s capacity, • Do not remove cord or strain relief. Do not lift the electrical or mechanical failure in the pump, etc.) may pump by the power cord (See ‘Cord Lift Warning’). For parts or assistance, call Jung Pumpen Customer Service at 1-800-642-5930... -
Page 3: Installation
Can burn or kill. 3. lifting or supporting the pump by the power Do not lift pump by power cord will void the warranty. cord. 6262 0910 For parts or assistance, call Jung Pumpen Customer Service at 1-800-642-5930... -
Page 4: Electrical
+ 10% of the nameplate voltage. If in doubt 30 white 30 orange 30 hite r nge consult a licensed electrician. 32 white 32 blue Figure 5: Three phase delta configuration wiring diagram For parts or assistance, call Jung Pumpen Customer Service at 1-800-642-5930... -
Page 5: Control Panels
If a Jung pumpen control panel is not used, install a sensor probe. Check the oil condition in the seal control panel with circuit breaker or fused disconnect chamber quarterly in heavy duty service or annually in as required by local code. -
Page 6: Maintenance
10. attach motor unit to volute casing. Finger tighten four 5 mm allen screws, then torque each to 5.9 ft-lb (8 nm). the cable entry point is opposite the discharge opening. For parts or assistance, call Jung Pumpen Customer Service at 1-800-642-5930... - Page 7 16. refill pump with specified amount of fresh, clean oil. do not overfill. 17. position pump vertically and check for free impeller rotation. the pump is ready to return to service. For parts or assistance, call Jung Pumpen Customer Service at 1-800-642-5930...
-
Page 8: Repair Parts
Repair Parts For parts or assistance, call Jung Pumpen Customer Service at 1-800-642-5930 For parts or assistance, call Jung Pumpen Customer Service at 1-800-642-5930... - Page 9 * seal set includes all o-rings, shaft cover, supporting washer, rotary shaft seal and mechanical seal to service entire pump. For parts or assistance, call Jung Pumpen Customer Service at 1-800-642-5930 For parts or assistance, call Jung Pumpen Customer Service at 1-800-642-5930...
-
Page 10: Troubleshooting
Consult dealer. liquid level controls incorrectly installed reposition or replace as necessary. or defective. pump too small for inlet flow. Consult dealer about larger pump or second pump. For parts or assistance, call Jung Pumpen Customer Service at 1-800-642-5930... -
Page 11: Warranty
Your only remedy, and Jung Pumpen’ s only duty, is that Jung Pumpen repair or replace defective products (at Jung Pumpen’ s choice). You must pay all labor and shipping charges associated with this warranty and must request warranty service through the installing dealer or selling distributor as soon as a problem is discovered. -
Page 12: Product Specifications
440.5 17.34 V2d-43 V3d-01 15.85 402.5 525.5 20.69 15.85 V3d-21 V3d-03 15.18 V3d-23 385.5 15.18 475.5 18.72 15.18 V3d-43 V5d-43 486.5 19.15 11.77 187.5 7.38 14.76 3.82 25.12 V7d-43 For parts or assistance, call Jung Pumpen Customer Service at 1-800-642-5930...
Need help?
Do you have a question about the V1D-01 and is the answer not in the manual?
Questions and answers