Fujitsu ARYG72LHTA Design & Technical Manual page 44

¢ Remote controller master/slave setting
NOTE: Set only one Master remote controller.
1. To activate the address setting mode, hold down the three buttons of "MENU", "<", and "EN-
TER" at the same time for 2 seconds or longer. Menu 2 setting screen is displayed.
2. Select the "06" in Menu 2 settings. Then press the "ENTER" button.
3. Select the "0: Master" or the "1: Slave" with the "+" or "-" buttons.
4. Press the "ENTER" button. If there is no problem, return to Menu 2 items selection screen.
In the case of settings at initial booting, "Monitor mode screen" is displayed.
• There's 0 or more than 2 "Master" units: The number will be displayed.
• "Master" is 0: Press the "ENTER" button to return to the Menu 2 item selection screen.
• "Master" is more than 2: Press the "ENTER" button to return to the screen of step 2.
• "Master" is 0 or more than 2: Press the "MENU" button to return to the Menu 2 item selection
screen.
12-2. Function settings by using remote controller
: Master : Slave
Number of Master units
- 40 -
12. Function settings