2) NEUTRAL LIGHT N (GREEN).
Comes on when in neutral position.
3) CRUISE CONTROL LIGHT (GREEN).
Comes on to indicate operation of the Cruise Control.
4) HIGH BEAM LIGHT
It turns on to indicate that the high beam lights are
on and when the flasher is activated.
5) FUEL WARNING LIGHT
Comes on when fuel is low and there are about 4
litres of fuel left in the tank.
6) TURN INDICATOR LIGHTS
Illuminates and flashes when the turn indicator is in
7) ENGINE OIL PRESSURE LIGHT
Comes on when engine oil pressure is too low. It
must turn on at "KEY-ON", but must turn off a few
seconds after the engine has started. It may shortly
come on when the engine is hot, however, it should
go out as the engine revs up.
If the ENGINE OIL light stays ON, stop the
engine or it may suffer severe damage.
8) DTC WARNING LIGHT (AMBER YELLOW)
This light indicates DTC system enabling/disabling
Light off: DTC enabled and functioning;
Light ON flashing: DTC enabled, but with
Light steady ON: DTC disabled and/or not
functioning due to a fault in the control unit.
9) "ENGINE DIAGNOSIS - MIL" LIGHT
It turns on in the case of "engine" errors that in some
cases will lock the engine.
10) ABS LIGHT
Indicates ABS status.
Light off: ABS enabled and functioning;