Verifying The Installation; Power-On Commissioning; Logging In To The Web Server; Changing An Ne Id - Huawei PowerCube 500 PC500-300H1 Quick Manual

Erecting the Solar Hybrid Pole
1. Check whether the pole needs to be repainted. Repaint the damaged area of
the pole, and then use the crane to hoist the pole to the foundation.
13

Verifying the Installation

1. Check that the mounting kits are securely installed and all screws are tightened.
2. Check that all cables are reliably connected with correct polarity and there is no short circuit.
3. Check whether any screw holes are not installed with screws. If so, install screws at the holes.
4. Check that all idle cable holes in modules are protected with waterproof caps.
14

Power-On Commissioning

Powering On Modules
14.1
1. Check the indicators on the function module and lithium batteries. Ensure that the green indicators are blinking slowly and that the
yellow and red indicators are off.
2. If a problem is found, refer to the alarm definitions in the user manual for troubleshooting.
3. Observe the board indicators in the maintenance compartment.

Logging In to the Web Server

14.2
1. Use a mobile phone or laptop to search for devices by
searching for WIFI. (Set the laptop to automatically obtain
IP, even after the WIFI will automatically assign an IP
address.)
2. Use the browser to enter the network element default IP,
Enter the Web Server login interface, Enter the values of
"User Name", "Password", and "Verification Code".
3. Click "Login".
NOTE

Default network element IP address: 192.168.1.1.
 The Default user name: szhw. Default password: Changeme_123.
14.3

Changing an NE ID

1. Choose Configuration > NE Attribute from the Function Tree.
2. Enter the name of the NE in the Name field.
3. Click "Apply".
2. Secure the pole to the foundation.
NOTE
The Default WIFI
name: RMn-******.
Default password:
Modify_123.
13
NOTE
Normally, The STAT, PWR,
and WIFI indicators on the
EG8P panel are: green.