Multiline Operation; To Hold A Call - NEC DT830 Series User Manual

MULTILINE OPERATION

DT830 DT430/410
You can answer an incoming call to the other station to
press the MULTILINE key (which is preassigned the
other station number).
To Originate a Call
STEP 1: Press the MULTILINE key.
STEP 2: Lift the handset or press
Central Office access code (i.e.9 (US), 0
(Aust)).
STEP 3: Dial the desired number.
To Answer a Call
STEP 1: Press the MULTILINE key (ringing and flash-
ing LED alert user to incoming call).
STEP 2: Lift the handset or press
STEP 3: Speak with the incoming party.
Speaker
key. Dial the
Speaker
key.
100

TO HOLD A CALL

STEP 1: Press
HOLD
flashes.
HOLD
1:25 PM
Mic
Note:
If held line appears on other stations, the associ-
ated LED flashes red slowly.
To Retrieve
STEP 1: Lift the handset or press
STEP 2: Press the held line key. Use the handset to
converse.
Note: Any station with this line key appearance can
retrieve the call.
If unanswered
STEP 1: After preprogrammed time, Automatic Recall
is initiated.
STEP 2: Visual and audible signal (rapid flash and ring
burst) is sent to the station that placed call on
hold.
Note: Hold shows as a flashing green LED on your
phone. The same line on other phones shows as
a flashing red LED. Recall shows as a flashing
green LED on your phone and flashing red LED
on other phones with the same line.
DT830 DT430/410
key. The held line key wink
Held Station Number
2001
MON 11 MAY 2015
>>>
Speaker key.