Velleman VTTEST3 Operation Manual

Voltage tester

OPERATION MANUAL

VTTEST3

1. SAFELY RULES

- This tester is designed and tested in accordance with EN publication

61010-1 pollution degree 2 and installation category (Overvoltage

category) III 600V.

- This tester has been tested according to the following EC Directives :

- 89/336/EEC (EMC of Nov., 1992, Electromagnetic compatibility)

EN50081-1 & EN50082-1.

- 73/23/EEC (Product Safety Law of June 11, 1979, Low Voltage Directive

of February 19, 1973).

- This tester is designed for to be indoor use at temperature 5°C to 40°C and

altitude up to 2000m.

- This tester is designed for "TOUCH" testing only. Do not keep continuous

contact with the unit under test for over 10 seconds, especially to high

voltage.

- Test on known live circuits to familiarise yourself with the response from a

live cable.

- Do not use the tester if the tester or the test probes look damaged or if you

suspect that the tester is not operating properly.

- When using the probes, keep your fingers behind the finger guard on the

probes.

- Always ensure probes are dry and do not work with wet hands.

Important information see manual

VOLTAGE TESTER

VTTEST3

Ground

Double insulation

Table of Contents

Do you have a question about the VTTEST3 and is the answer not in the manual?

Page 1 OPERATION MANUAL VTTEST3 VOLTAGE TESTER 1. SAFELY RULES - This tester is designed and tested in accordance with EN publication 61010-1 pollution degree 2 and installation category (Overvoltage category) III 600V. - This tester has been tested according to the following EC Directives : - 89/336/EEC (EMC of Nov., 1992, Electromagnetic compatibility)
Page 2 This tester is designed to have no serviceable parts and is maintenance free. Periodically wipe the tester with a soft cloth, do not use abrasives or solvents. Ensure that no water gets inside the equipment to prevent possible shorts and damage. WARNING Consult a qualified electrician if in doubt for application. VTTEST3...