Table of Contents
Advertisement
LCO-IV------------------------------------------------------------------
16. The voltage that drops between the power supply terminals (Vee, V., V
2 ,
V,) and each common or segment output terminal.
17. External Halt Timing Chart
VCC
HLT
GND
4.5V
:f"------
-----------i---
4.5V
. - - - - - - - , - -.VDH
tH
tRC
~-------------------tHLT--------------------~~
18. RESET Input Condition
HLT
=
VCC
VCC
tfRST
trRST
tfRST
• tRST. includes the time that required from the power ON until the operation gets into the constant state .
• tRS T
2
is applied when the operation is in the constant state.
Reset circuit at power on is not installed. Simple reset circuit at power on is the following.
Vee
+
RESET
19. The supply current at Vee = VOH = 2.3V in "Halt" state, in the case that the crystal oscillation for timer is not selected.
Current that flows in the input/output circuit and in the power supply circuit for LCD is excluded .
• ELECTRICAL CHARACTERISTICS (Vee
=
2.5
to
5.5V)
• ABSOLUTE MAXIMUM RATINGS
Item
Symbol
Value
Unit
Note
Supply Voltage
Vcc
-0.3 to +7.0
V
Terminal Voltage
Vn
-0.3 to V cc +0.3
V
Maximum Total Output Current (1)
-~lo1
25
mA
(Note 3)
Maximum Total Output Current (2)
~lo2
25
mA
(Note 3)
Operating Temperature
Topr
-20 to +75
°C
Storage Temperature
Tstg
-55 to +125
°C
(NOTE)
1. Str_ above those lilted under "ABSOLUTE MAXIMUM RATINGS" may cause permanent damage to the device. Normal opera-
tion should be limited to those conditions specified under "ELECTRICAL CHARACTERISTICS -1" and "·2". The use beyond these
conditions may cause LSI's malfunction and at the same time affects devica reliability.
2. All voltages are with respect to GND.
3. Maximum Total Output Current is the total sum of output currents which can flow out or in simultaneously.
4. Power supply condition VCC
~
V1
~
V2
~
V3
~
GND should be maintained.
180
Advertisement
Table of Contents
