Table of Contents
Advertisement
--------------------------------------------------------HMCS47C,HMCS47CL
An interrupt request generated by the leading pulse is latched
into the input interrupt request F/F (I/RI) on the input side. If
the Interrupt Enable F /F (I/E) is "I" (Interrupt Enable State),
an interrupt occurs immediately and the I/RI F/F and the liE
F/F are reset. If the liE F/F is "0" (Interrupt Disable State), the
I/RI F/F is held at "I" until the HMCS47C gets into the Inter-
rupt Enable State.
The IFO F/F, the IFI F/F, the INTo pin and the INTI pin
can be tested by interrupt instruction. Therefore, the INTo and
the INTI can be used as additional input pins with latches.
The INTo pin and INTI pin can be provided with Pull up
MOS using a mask option as shown in Figure 20.
No Pull up MOS
r----'!Ef-.,
I/O Enable---'
I
I
PMOS
I
I
_______ .J
Input circuit
An interrupt request from the timer/counter is latched into
the timer interrupt request F/F (I/RT). The succeeding opera-
tions are same as an interrupt from the input. Only the excep-
tion is that, since an interrupt from the input precedes a timer/
counter interrupt, the input interrupt occurs if both the I/RI
F/F and the I/RT F
IF
are "1" (when the input interrupt and
the timerlcounter interrupts are generated simultaneously).
During this processing, the I/RT F/F remains "1". The timer/
counter interrupt can be implemented after the input interrupt
processing is achieved.
The interrupt circuit block diagram is shown in Figure 21.
Vee
I/O
With Pull up MOS (PMOS)
I
I
I
I
I
I
~
_______ .J
Input circuit
*
When "Disable" is specified for the I/O State at the Halt State, the
I/O Enable signal shown in the figure turns off the input circuit and
Pull up MOS.
IFO,IF1
Figure
20
Configuration of
INTo
and
INTI
To Status F/F
liE
SEIE
S
Q
REIE
R
~---I---l-----I/RI
(Interrupt
Mask Signal)
INT
L-------~--------+__I/RT
Set has priority over Reset.
D F/F (Delayed by One Instruction Cycle)
Figure 21 Interrupt Circuit Block Diagram
127
Advertisement
Table of Contents
