Sony DVCAM DSR-25 Operating Instructions Manual page 30

Playback
To video equipment without a DV jack
You can connect this unit to video equipment without
a DV jack. Use this unit as follows.
Recorder
Connect either an S-video cable or 75 Ω coaxial cable
as a video cable.
Note
If you connect the input connectors of this unit to the
output connectors of a recorder or that of a monitor, a
humming noise may be generated or the image may be
distorted. If these phenomena occur, perform one of
the following:
• Set EE/PB SEL on the DISPLAY SET menu to PB.
• Set the INPUT SELECT selector to a position where
a signal is not currently being input.
• Disconnect the cables.
30
(GB) Chapter 2 Playback and Recording
Monitor
Audio input
Video input
S-video input
Audio cable (Phono jack) (not supplied)
75 Ω coaxial cable (not supplied)
S-video cable (not supplied)
Monitor
DSR-25 (player)
(rear panel)
: Signal flow