Table of Contents
Advertisement
Programming the remote
You can customize the remote to match the
components connected to your receiver. You
can even program the remote to control non-
Sony components and also Sony components
that the remote is normally unable to control.
The procedure below uses as an example a case
in which a Aiwa VCR is connected to the
VIDEO 2 jacks on the receiver.
Before you begin note that:
– You cannot change the settings of TUNER and
PHONO.
– The remote can control only components that
accept infrared wireless control signals.
Be sure to turn on the receiver and point
the remote towards the receiver when
performing the following procedure.
1
Press RM SET UP.
The set up list appears.
p IR SET
MENU EDIT
AUTO POWER
BACK LIGHT
2
Move the easy scroll key to select “IR
SET”, then press the key to enter the
selection.
The IR SET list appears.
<IR SET>
[VIDEO 1 ]
p [VIDEO 2 ]
[VIDEO 3 ]
3
Move the easy scroll key to select the
component (“VIDEO 2”, for example),
then press the key to enter the
selection.
The category list appears.
Category?
p VCR
T V
L D
4
Move the easy scroll key to select the
category (i.e., the component that is
actually connected to the
corresponding jacks; in this case,
“VCR”), then press the key to enter the
selection.
The maker list appears.
Maker?
p Sony VTR1
Sony VTR2
Sony VTR3
5
Move the easy scroll key to select the
maker of the component (“Aiwa”, for
example), then press the key to enter
the selection.
When programming the remote to
control Sony component
Select “Sony.”
Programming is now completed.
To cancel programming
Move the easy scroll key to select “Exit” or
“Cancel” during any step, then press the key to
enter the selection.
Tips
• You can freely assign any component to USER 1
and 2 items in the IR SET list
1 Do steps 1 and 2 in “Programming the Remote”.
2 Move the easy scroll key to select “USER 1” or
“USER 2,” then press the key to enter the
selection.
3 Continue from step 3 in “Programming the
Remote” to select the category and maker of the
component.
• To operate the tuner on a Sony receiver, make sure
that the tuner function’s maker list is set to “Sony
STR-02”.
GB
Page 15
Hide quick links:
Advertisement
Table of Contents
