Sony DVS-9000 User Manual page 214

7
8
Carrying out a color mix for the key edge fill matte
When you select 'Matte' for the edge fill of a border, drop border, or shadow,
you can create a combination of color 1 and color 2 using a wipe pattern
generated by the dedicated pattern generator.
Use the following procedure.
214
Key Setting Operations Using Menus
Knob Parameter Adjustment
1 Luminance Luminance
2 Saturation Saturation
3 Hue Hue
To make the edge soft, press [Soft Edge] to set it on, and adjust the
softness.
Knob Parameter Adjustment
1 Soft Edge softness
• For a normal edge, when [Soft Edge] is enabled, "key drop ON mode"
(see page 42) turns on.
• When a luminance key or linear key is selected as the key type, and clean
mode is enabled, enabling [Soft Edge] turns the clean mode off.
To make separate fine adjustments to the positions of the left, right, top,
and bottom of the source edge, press [Fine Key], to set it on, and adjust the
following parameters.
Knob Parameter Adjustment
1 Top Key top edge position
2 Left Key left edge position
3 Right Key right edge position
4 Bottom Key bottom edge position
6 H Phase Key horizontal position
7 V Phase Key vertical position
Note
In the emboss function it is not possible to set [Fine Key] on.
• When the edge type is normal, drop border or shadow, enabling the [Fine
Key] function fixes the key in the "Key drop ON" mode (see page 42).
• When applying a border to the key edge, enabling the [Fine Key]
function halves the border width setting range.
Setting values
0.00 to 100.00
0.00 to 100.00
0.00 to 359.99
Setting values
0.00 to 100.00
Setting values
2.00 to +2.00
2.00 to +2.00
2.00 to +2.00
2.00 to +2.00
Left edge position
value shown
Top edge position
value shown