Sony DVS-9000 User Manual page 213

When emboss is selected:
Knob Parameter
1 Width
2 Position
3
a)
Density
a) The Density adjustment only affects the key edge. This can be adjusted separately from
Key Density, and if Key Density is set to 0.00, the embossed edge effect only can be
applied.
To make edge fill adjustments, carry out the settings in step 6.
4
Select the edge fill signal in the <Edge Fill> group.
Utility 1 Bus: signal selected on the utility 1 bus
Matte: signal from dedicated color matte generator.
It becomes possible to adjust color 1.
Knob Parameter
1 Luminance
2 Saturation
3 Hue
When the edge type is outline, in place of the edge fill signal, the selected
key fill signal fills the outline, and elsewhere remains as the background.
5
Carry out the following operation, depending on the selection in step 4.
When [Utility 1 Bus] is selected: Press the key delegation button
[UTIL1], turning it on, and select the signal in the key row.
When [Matte] is selected: Press [Matte Adjust] in the same EDGE menu,
to display the Matte Adjust menu, and adjust a single color or two-
color combination color matte.
You can select whether to use a single color matte or a two-color
combination color matte in the <Edge Matte> group.
For the color mix operation, see "Carrying out a color mix for the key edge
fill matte" (page 214).
6
When emboss is selected for the edge type, adjust the color in the <Emboss
Fill> group.
To adjust matte 1 press [Matte1], and to adjust matte 2 press [Matte2], then
adjust the following parameters.
Adjustment
Width
Position
Density
Adjustment
Luminance
Saturation
Hue
Key Setting Operations Using Menus
Setting values
0.00 to 8.00
0.00 to 359.99
0.00 to 100.00
Setting values
0.00 to 100.00
0.00 to 100.00
0.00 to 359.99
213