Selecting The Command Mode Of The Remote - Sony STR-DE898 Operating Instructions Manual

Remote Operations
Button
x qd
VCR/
CD player/
VCD player/
LD player/
DVD player/
MD deck/
DAT deck/
Tape deck/
Blu-ray disc
recorder/
Hard disc
recorder/PSX
O ws
VCD player/
LD player/
DVD player/
Satellite tuner/
Blu-ray disc
recorder/
Hard disc
recorder/PSX
V/v ws
Receiver
B/b ws
Receiver
V/v/B/b VCR/
ws
Satellite tuner/
DVD player
-/-- wg TV/
Satellite tuner/
Blu-ray disc
recorder/
Hard disc
recorder/PSX
2ND 3
Remote
Notes
• Some functions explained in this section may not
work depending on the model.
• The above explanation is intended to serve as an
example only. Therefore, depending on the
component the above operation may not be possible
or may operate differently than described.
• To activate the buttons with orange printing, press
ALT first before pressing the buttons.
• When you press input buttons (VIDEO1, VIDEO2,
VIDEO3, TV/SAT or DVD), the input mode of the
TV might not switch to the corresponding input
mode that you want. In this case, press TV/VIDEO
button to switch the input mode of the TV.
Function
Stops playback.
Returns to the previous
menu or exits the menu.
Selects a menu item.
Adjusts or changes the
setting.
Selects a menu item.
Selects the channel
entry mode, either one
or two digit.
Selects the command
mode of the remote.
Selecting the command
mode of the remote
Set the remote command mode using the RM
SET UP button and the remote command mode
buttons.
Selecting the command mode
You can switch the command mode (AV1 and
AV2) of the remote. If the command mode of the
receiver and the remote is different, you cannot
use the remote to operate the receiver.
Press AV1 or AV2 while holding down RM
SET UP.
The indicator flashes once (twice for AV2) ,
then the command mode switches.
To check the command mode of
the remote
Press RM SET UP. You can check the remote by
the indicator.
Mode
AV1
AV2
To reset the remote to factory
settings
Press ?/1, AV ?/1 and MASTER VOL – at
the same time.
The indicator flashes 3 times, then goes off.
Note
If the command mode of the receiver and the remote is
different, you cannot use the remote to operate the
receiver. To change the command mode of the
receiver, see page 59.
Indicator flashes
once
twice
49 GB