Sony STR-DE345, STR-DE245 Operating Instructions Manual page 11

1
Press one of the Function buttons to select the
component you want to use.
The Function buttons on the remote are factory-
set as follows:
To listen to or watch
Radio programs
Compact discs (CD)
MiniDisc (MD) or
Audio tapes
TV programs or
Satellite receiver
VHS Video tapes
(VTR-3 mode)
DVD player/
Dolby Digital decoder
If you want to change the factory setting of a
button, see the next section.
The receiver and the selected component turn on.
If the component does not turn on
Press the power switch on the component.
2
Start playing.
Refer to "Remote Button Descriptions" on page 25
for details.
Changing the factory setting of a
function button (STR-DE245 only)
If the factory settings of the FUNCTION buttons don't
match your system components, you can change them.
For example, if you have two CD players and you
don't have a tape deck or an MD deck, you can assign
the MD/TAPE button to your second CD player.
Note that the settings of the TUNER button cannot be
changed.
Numeric
buttons
> 10
.
Press
TUNER
CD
MD/TAPE
(INITIAL-MD MODE)
TV/SAT
(INITIAL-TV MODE)
VIDEO
DVD/LD
(INITIAL-DVD MODE)
AV ?/1
?/1
Function
buttons
ENTER
MASTER VOL –
Receiver Operations
1
Hold down the Function button whose function
you want to change (for example, MD/TAPE).
2
Press the corresponding button of the component
you want to assign to the Function button (for
example, 1 - CD player).
The following buttons are assigned to select the
functions:
To operate
CD player
DAT deck
MD deck
Tape deck A
Tape deck B
LD player
VCR (remote control mode VTR 1*)
VCR (remote control mode VTR 2*)
VCR (remote control mode VTR 3*)
TV
DSS (Digital Satellite System)
DVD
VCD player
* Sony VCRs are operated with a VTR 1, 2 or 3 setting.
These correspond to Beta, 8mm and VHS respectively.
Now you can use the MD/TAPE button to control
a second CD player.
To change the AUX function to another function
Hold down SLEEP and press the corresponding button of
the component you want to assign it to.
To change the 5.1 CH function to another function
Hold down AV ?/1 and press the corresponding button of
the component you want to assign it to.
To reset a button to its factory setting
Repeat the above procedure.
To reset all the function buttons to their factory setting
Press ?/1, AV ?/1 and MASTER VOL – at the same time.
Press
1
2
3
4
5
6
7
8
9
0
>10
ENTER
.
11 US