Hooking Up The Audio Components - Sony SCD-1 Operating Instructions (primary manual) Operating Instructions Manual

Hooking Up the Audio Components

Connect the Super Audio CD player to an audio
component. Be sure to turn off the power of all
components before making connections and connect
securely to prevent noise.
Connecting via LINE OUT UNBALANCED
jacks
Use an audio connecting cord for this connection. Be sure to
match the colour-coded pin to the appropriate jacks: white (left)
to white and red (right) to red.
Audio connecting cord (supplied)
White (L)
Red (R)
Connecting via LINE OUT BALANCED
connectors
Use an XLR (balanced) cord for this connection. When connecting
an XLR (balanced) cord to the LINE OUT BALANCED
connectors, set the BALANCED OUT ON/OFF switch on the rear
panel of the player to ON.
XLR (balanced) cord (not supplied)
Polarity of LINE OUT BALANCED connector
1
LINE OUT (ANALOG)
R
R
White (L)
Red (R)
1: GROUND
2: HOT (+)
3: COLD (–)
3 2
BALANCED COMMAND
OUT MODE
BALANCED L
1:GROUND
ON CD1
2:HOT (+)
OFF CD2
3:COLD ( )
UNBALANCED L
Stereo amplifier, etc.
INPUT
CD
L
R
Connecting via DIGITAL OUT OPTICAL
connector
Use an optical digital cable for this connection. When connecting
the optical digital cable to the DIGITAL OUT OPTICAL
connector, take the cap off the connectors and push the cable
plugs in until they click into place.
Be sure to show "16 bit" in the display by pressing DIGITAL OUT
on the upper side of the player. Be careful not to bend or twist the
optical cable.
Optical digital cable (not supplied)
Note
Only the audio signals of the CD can be output from the
DIGITAL OUT connectors. Those of the Super Audio CD cannot
be output through DIGITAL OUT.
Connecting via DIGITAL OUT COAXIAL
connector
Use a coaxial digital cable to connect the audio components
equipped with coaxial digital input connectors. When connecting
the coaxial digital cable, be sure to show "16 bit" in the display
by pressing DIGITAL OUT on the upper side of the player.
Coaxial digital cable (not supplied)
Note
Only the audio signals of the CD can be output from the
DIGITAL OUT connectors. Those of the Super Audio CD cannot
be output through DIGITAL OUT.
DIGITAL OUT
CD
COAXIAL
~AC IN
STANDARD
CUSTOM
TA - E1 / N1
OPTICAL
5
GB