First Step; Windows Xp Setup - Epson RC520 Safety And Installation

3. First Step

This section indicates the procedure to execute simple program after turning ON
the power.
Make sure that the Robot system is installed safely by following the description in
1. Safety and 2. Installation. Then, operate the Robot system in the following
procedures.

3.1 Windows XP Setup

When using Windows XP, make sure to set up the system.
NOTE Do NOT stop the Windows XP Setup and turn OFF the Controller before
completing this setup.
Otherwise the Controller will NOT start up again and you must execute Windows
recovery.
After a short time after turning ON the Controller, "Windows XP Setup" starts
automatically.
Setup procedure is as follows. Follow the instruction in the dialog.
(1) Welcome to Microsoft Windows XP
Click the <Next> button to continue the setup.
(2) License Agreement
This dialog is for selecting agree or disagree to the displayed agreement.
When you agree to the agreement, select the option to agree and click the
<Next> button. (If you select the option to disagree, the Windows setup will
be canceled.)
After agreeing to the "License Agreement", the setup starts automatically.
(3) Windows Startup
Windows reboot automatically after finishing the setup and will be able to
use the Controller.
RC520 Safety and Installation Rev.2
3. First Step
47