Setting Presets Through Manual Tuning - Sony MHC-GS200 Operating Instructions Manual

Setting presets through
manual tuning
1
Press TUNER/BAND repeatedly to
select "FM" or "AM".
2
Press TUNING – or + repeatedly to tune
in the desired station.
3
Press MENU.
4
Press PRESET – or + repeatedly until
"MEMORY" appears, then press
ENTER.
A preset number appears.
5
Press PRESET – or + repeatedly to
select the desired preset number.
6
Press ENTER.
7
Repeat steps 1 to 6 to store other
stations.
Other Operations
To Do this
Tune in a station Follow the procedure described in
with a weak "Setting presets through manual
signal tuning".
Stop setting Press MENU.
presets
Change the Start over from step 1.
preset station
To change the AM tuning interval
The AM tuning interval is factory-set to 9 kHz
(10 kHz in some areas). To change the AM
tuning interval, tune in any AM station first,
then turn off the system. While holding down
ENTER, turn the system back on. When you
change the interval, all the AM preset stations
are erased. To reset the interval, repeat the
same procedure.
Note
You cannot change the AM tuning interval in
Power Saving Mode.
Tips
• The preset stations are retained for about a day even
if you disconnect the mains lead or if a power
failure occurs.
• You can label the preset stations (see page 22).
• To improve broadcast reception, reorient or move
the supplied antennas near a window or outdoors.
US
21