• When the additional secondary side is mounted after one has been already set, slide the additional secondary side to
mount it in its specified position after setting it away from the already mounted one as shown in this section.
• After installation, confirm that the primary side does not contact the secondary side.
• Keep the cumulative pitch error of the mounting screw holes to within ±0.1 mm. When two or more pairs of secondary side
are installed, clearance may be left between the secondary sides depending on the installing method and the number of
Place one unit of secondary side on the stage.
Press the side face of the secondary side to the stage, and securely fix it with the hexagon socket head cap screw.
Secure the secondary side with the hexagon socket head cap screw.
In the opposite position of the secondary side that is installed in 1) and 2), press the side face of the secondary side
which is installed as the second one, and fix it with the hexagon socket head cap screw as temporary joint.
Using a tool for fitting end-surface position, fit the end-surface of the secondary side which is installed in 1) and 2) and
that of temporarily fixed one in 3), and securely fix the temporarily fixed secondary side with the hexagon socket head
Tool for fitting end-surface position or others
*1 It should be prepared by the customer.
Temporarily fix the secondary
side with the hexagon socket
head cap screw, and secure
the secondary side after fitting
its end surface to the tool.
5 Linear servo motor
5.6 LM-K2 series