National Approvals; En54 Information - Honeywell Morley-IAS ZX Series Commissioning Manual

MORLEY-IAS
CAUTION: A Lithium Battery is used for Data Retention.
Replace only with the same or equivalent type. Contact the Service Organisation for
Replacement.
This symbol identifies that the panel uses a safety isolating mains transformer.

1.3 National Approvals

This equipment must be installed and operated in accordance with these instructions and the
appropriate national, regional and local regulations specific to the country and location of the
installation. Consult with the appropriate Authority Having Jurisdiction (AHJ) for confirmation of the
requirements.

1.4 EN54 Information

EN54-2 13.7
EN54
Maximum of 512
!
sensors / manual
call points per
panel.
•
This Fire Control Panel complies with the requirements of EN54-2/4 1997. In addition
to the basic requirements of EN54, the panel conforms to the following optional
EN54
functions.
Option
Indication:
Controls:
Outputs:
•
The power supplies for the ZX1Se, ZX2Se, ZX5Se and ZX10Se range of panels
EN54
complies with the following clauses of EN54-4.
Power Supply Functions
Derive power supply from main power source
Derive power supply from a standby battery source
Charge and monitor the standby battery source
Detect & signal power supply faults
Page 2
•
The ZX1Se, ZX2Se, ZX5Se and ZX10Se range of panels has many
features, which if used inappropriately, may contravene the
requirements of EN54. Where such a possibility may arise, a suitable
warning is given with brief details of the EN54 requirement and the
relevant section it pertains to. A typical EN54 non-compliance
warning is illustrated.
Fault signals from points
Coincidence Detection
Delays of Actioning Outputs
Disablement of each address point.
Test condition
Outputs to fire alarm devices
Document No. 996-175-000-1, Revision 01
ZX Fire Alarm Control Panels
EN54-2 Clause
8.3
7.12
7.11
9.5
10
7.8
EN54-4 Clause
5.1
5.2
5.3
5.4
Commissioning Manual