Using The Remote Control Unit - Sharp PN-CE701H Operation Manual

Using the remote control unit

1
2
3
4
5
6
7
8
9
10
1. HDMI
Switch the input mode to HDMI 1, HDMI 2 or HDMI 3.
2. Numeric input buttons
These buttons are used for setting such as LAN setting.
3. MUTE
Turns off the volume temporarily.
Press the MUTE button again to turn the sound back to the
previous level.
4. MODE (Display mode selection)
In video input mode (other than APPLICATION), each time you
press this button, the picture mode changes in the following
order:
STD (Standard) → Soft → High Illuminance → STD...
• High Illuminance is a display with colors suited to bright
locations.
5. VOLUME +/- (Volume adjustment)
Press + or - to adjust the volume.
6. INFORMATION
11
In video input mode (other than APPLICATION), use this to
display the input terminal and the signal.
12
13
7. FUNCTION
Use this to display the FUNCTION menu. (See page 36.)
8. ENTER
Confirms the setting.
9. FREEZE
Freezes the video shown on the monitor.
To cancel, press any button other than the POWER button,
14
MUTE button or VOLUME button.
In some cases a residual image may occur. Do not freeze the
15
video for a long time.
16
17
10. Buttons for LocalMM or operating the HDMI-connected
device
18
When used in LocalMM, the buttons that can be used vary
depending on the file that is played.
19
When HDMI CEC is set to On, only the POWER button is
20
enabled for the device connected through the HDMI interface.
11. ID SET
This is not used with this monitor.
12. OPTION
Switch the input mode to APPLICATION or OPS.
13. DP (DisplayPort)
This is not used with this monitor.
14. SIZE (Screen size selection)
In video input mode (other than APPLICATION), each time
you press this button, screen size is changed. (See page 23.)
15. PIP/PbyP
This is not used with this monitor.
16. BRIGHT +/- (Brightness adjustment)
Press + or - to adjust the brightness.
Basic Operation
21
E