Hooking Up The System - Sony CDP-CX260 Operating Instructions Manual

Hooking Up the System

Overview
This section describes how to hook up the CD player to
an amplifier. Be sure to turn off the power of each
component before making the connections.
Transmitter/receiver
To S-LINK/CONTROL A1
jack
To S-LINK/CONTROL A1
jack
To TMR-IA10
To an AC outlet
To line output (L) To line output (R)
To audio input
: Signal flow
What cords will I need?
Audio cord (1) (supplied)
White
(L)
Red
(R)
DC-cable (1) (supplied)
Hookups
When connecting the audio cord, be sure to match the
color-coded cords to the appropriate jacks on the
components: Red (right) to Red and White (left) to
White. Be sure to make connections firmly to avoid
hum and noise.
To DC IN 6V
• To connect the transmitter/receiver
DIGITAL OUT
(OPTICAL)
CD player
COMMAND MODE
• If you have a digital component such as a digital
Amplifier
To an AC outlet
White
(L)
Red
(R)
Getting Started
Getting Started
CD player
2ND CD LINE
IN OUT
L L
R R
Connect the transmitter/receiver via the TO TMR-IA10 jack
using a DC-cable (supplied) and via the S-LINK CONTROL
A1 jack using a monaural (2P) mini-plug cord (supplied).
CD player
TO TMR - I A10
( TRANSMITTER RECEIVER )
DC OUT 6V
S - L I NK
CONTROL A1
amplifier, D/A converter, DAT or MD
Connect the component via the DIGITAL OUT (OPTICAL)
connector using an optical cable (not supplied). Take off the
cap and plug in the optical cable.
POC-15
Optical cable (not supplied)
Digital component
CD player
DIGITAL OUT
OPTICAL
Note
When you connect via the DIGITAL OUT (OPTICAL)
connector, noise may occur when you play CD software
other than music, such as a CD-ROM.
Playing CDs
Amplifier
INPUT
CD
L
R
Transmitter/receiver
DC IN 6V
CONTROL A1
DIGITAL INPUT
OPTICAL
5