Download  Print this page

Points To Note On Disassembly And Reassembly; Note On Locations Prohibited From Disassembly; Manual Carriage Movement - Canon W6400 Series Service Manual

Hide thumbs

Advertisement

4.3 Points to Note on Disassembly and Reassembly

4.3.1 Note on locations prohibited from disassembly

Locations that are prohibited from disassembly and cannot be adjusted outside of the factory have red screws instead of the regular-colored screws.
However, note that the color has been changed from the previous red screws.

4.3.2 Manual carriage movement

The carriage is moved by holding down the
when the power is turned off such as during assembly or disassembly, move the carriage by holding the knobs shown in the figure below.
Move the carriage as required during assembly and disassembly to prevent contact of the carriage with the parts that are removed.
The carriage does not move when capping has been performed. Refer to the procedures in DISASSEMBLY/REASSEMBLY > Points to Note on
Disassembly and Reassembly > Opening the Caps and Moving the Wiper Unit to remove the caps and move the carriage.
<New Do Not Disassemble red screw>
button or
button on the operation panel for at least 0.5 seconds when the printer is offline. However,
<Previous Do Not Disassemble red screw>
F-4-3
Knob
F-4-4
Chapter 4
0009-8782
0009-8783
Knob
4-3

Advertisement

Table of Contents

   Related Manuals for Canon W6400 Series

Comments to this Manuals

Symbols: 0
Latest comments: