Download  Print this page

Mtcart Full Soon (w01006); Feed Limit; Incorrect Media (w01021); No Full Bleed (w01022) - Canon W6400 Series Service Manual

Hide thumbs

Advertisement

6. Replace the system controller.

6.1.3.2 MTCart Full Soon (W01006)

<Cause>
This is displayed when an almost full (80 percent or more) maintenance cartridge is detected.
<Probable problem locations>
Maintenance cartridge, engine controller and system controller
<Remedy>
1. Maintenance Cartridge
Use SERVICE MODE>COUNTER>PRINTER>W-INK to check the waste ink absorber. Replace if the waste ink level is near the limit (1000ml).
2. Replace the engine controller.
3. Replace the system controller.
6.1.3.3 Feed Limit..(W0100F)
<Cause>
This is displayed when the engine controller has detected the feed limit of the media during manual feeding.
During back feeding, the print standby position (on feed roller) is the feed limit.
During forward feeding, the media sensor detects no roll media.
<Probable problem locations>
Engine controller, system controller
<Remedy>
1. Replace the engine controller.
2. Replace the system controller.

6.1.3.4 Incorrect Media (W01021)

<Cause>
During data reception, this is displayed when the media type required by the received data is different from the media type that is currently loaded.
<Probable problem locations>
Operation error, engine controller, system controller
<Remedy>
1. Check the operating procedures and reprint.
2. Replace the engine controller.
3. Replace the system controller.

6.1.3.5 No full bleed (W01022)

<Cause>
Printing data is unsuitable for Borderless Printing.
<Probable problem locations>
Printer operating procedure error.
<Remedy>
1. Check correct operating procedure and retry print operation.
6.1.3.6 W01030/W01031/W01032/W01034/W01035/W01036/W01037/W01038/W01039: GARO W0103x (number is
indicated by x)
<Cause>
During data reception, this is displayed when an error occurs in the data reception GARO command.
<Probable problem locations>
Operation error, system controller
<Remedy>
1. Check the operating procedures and reprint.
2. Replace the system controller.

6.1.4 Troubleshooting When Errors Occur

6.1.4.1 E02000/ Roll media end error

<Cause>
This is displayed when the media sensor has detected the roll media trailing edge during printing or loading of the roll media.
<Probable problem locations>
Roll media, media sensor, engine controller and system controller
<Remedy>
1. Roll media
Chapter 6
0008-6489
0008-6491
0008-6492
0008-6493
0010-0355
0008-6496
6-5

Advertisement

Table of Contents

   Related Manuals for Canon W6400 Series

Comments to this Manuals

Symbols: 0
Latest comments: