Sony STR-DH810 Operating Instructions Manual page 38

3: Confirming/saving the
measurement results
1
Confirm the measurement
result.
When the measurement ends, a beep
sounds and the measurement result
appears on the display.
Measurement process
[Display]
Completes properly
[SAVE EXIT]
Fails
xxx xx
[E - : ]
2
View the measurement result.
Press AMP and then press V/v repeatedly
to select the item. Then, press
Item and explanation
EXIT
Exits the setting process without saving the
measurement results.
LEVEL INFO.
Displays the measurement result for speaker
level.
DIST. INFO.
Displays the measurement result for speaker
distance.
PHASE INFO.
Displays the phase of each speaker (in phase/
out of phase). See "When you select "PHASE
INFO."" (page 39).
WARN CHECK
Displays warning concerning the
measurement results. See "When you select
"WARN CHECK"" (page 39).
SAVE EXIT
Saves the measurement results and exits the
setting process.
RETRY
Performs the Auto Calibration again.
38
GB
Explanation
Proceed to step
2.
See "When error
codes appear"
(page 39).
.
3
Save the measurement result.
Select "SAVE EXIT" in step 2.
"COMPLETE" appears on the display
and the settings are registered as selected
position number.
4
Select the calibration type.
Press V/v repeatedly to select calibration
type, then press
Calibration type and explanation
FULL FLAT
Makes the measurement of frequency from
each speaker flat.
ENGINEER
Sets the frequency characteristics to a set that
matches that of the Sony listening room
standard.
FRONT REF
Adjusts the characteristics of all speakers to
match the characteristics of the front speaker.
OFF
Sets the Auto Calibration equalizer level to
off.
5
Disconnect the optimizer
microphone after you have
finished.
Note
If you have reposition your speaker, we recommend
that you perform Auto Calibration again to enjoy the
surround sound.
Tip
The size of a speaker (LARGE/SMALL) is
determined by the low frequency characteristics.
The measurement results may vary, depending on
the position of the optimizer microphone and
speakers, and the shape of the room. It is
recommended that you follow the measurement
results. However, you can change those settings in
the SPEAKER menu (page 74). Save the
measurement results first, then try to change the
settings if you want.
.