Preparing The Receiver; Initializing The Receiver; Selecting The Speaker System - Sony STR-DH810 Operating Instructions Manual

Preparing the Receiver

Initializing the receiver

Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their initial settings.
Be sure to use the buttons on the receiver for
this operation.
?/1
?/1
1
Press ?/1 to turn off the
receiver.
2
Hold down ?/1 for 5 seconds.
After "CLEARING" appears on the
display for a while, "CLEARED"
appears.
All the settings you have changed or
adjusted are reset to the initial settings.
34
GB
Selecting the speaker
system
You can select the front speakers you want to
drive.
Be sure to use the buttons on the receiver for
this operation.
?/1
SPEAKERS
Press SPEAKERS repeatedly to
select the front speaker system
you want to drive.
When select front speakers
connected to
The SPEAKERS FRONT A
terminals
The SPEAKERS SURROUND
BACK/FRONT HIGH/BI-AMP/
FRONT B terminals
Both the SPEAKERS FRONT A and
SPEAKERS SURROUND BACK/
FRONT HIGH/BI-AMP/FRONT B
terminals (parallel connection)
* To select "SP B" or "SP A B", set "SB ASSIGN"
to "SPK B" in the SPEAKER menu (page 80).
To turn off the speaker output
Press SPEAKERS repeatedly until the "SP A",
"SP B" and "SP A B" indicators on the display
do not light up.
"SPK OFF" appears on the display.
Note
You cannot switch the front speaker system by
pressing SPEAKERS when the headphones are
connected.
Light up
SP A
SP B*
SP A B*