Resetting Sound Fields To The Initial Settings - Sony STR-DG920 Operating Instructions Manual

Notes
• The sound fields for music and movies do not work
in the following cases.
– The multi channel input is selected.
– DTS-HD signals with a sampling frequency of
more than 48 kHz are being received.
– Dolby TrueHD signals with a sampling
frequency of more than 48 kHz are being
received.
– Signals with a sampling frequency of more than
48 kHz are being received.
– The multi channel PCM signals are received via
a HDMI IN jack with a sampling frequency more
than 48 kHz.
• When one of the sound fields for music is selected,
no sound is output from the subwoofer if all the
speakers are set to "LARGE" on the Speaker
settings menu. However, the sound will be output
from the subwoofer if
– the digital input signal contains LFE signals.
– the front and surround speakers are set to
"SMALL".
– the sound field for movie is selected.
– "Portable Audio" is selected.
Tips
• You can identify the encoding format of DVD
software, etc., by looking at the logo on the
package.
• Sound fields with DCS marks use DCS
technology. See "Glossary" (page 104).
• When the sound field's DCS mark is selected,
the Digital Cinema Sound lamp lights up on the
display.
To turn off the surround effect
for movie/music
Select "2ch Stereo" or "A.F.D. Auto" in the
Surround settings menu.
Resetting sound fields to
the initial settings
Be sure to use the buttons on the receiver for
this operation.
1,2
ON/STANDBY
POWER
TONE MODE TUNING MODE
MULTI CHANNEL DECODING
TONE TUNING
SPEAKERS
(OFF/A/B/A+B)
MEMORY/ 2CH/
ENTER DIMMER A.DIRECT
VIDEO 2 IN/PORTABLE AV IN
PHONES
VIDEO L AUDIO R AUTO CAL MIC
1
Press POWER to turn off the
receiver.
2
While holding down MUSIC,
press POWER.
"S.F. CLEAR" appears on the display and
all sound fields are reset to their initial
setting.
MASTER VOLUME
DISPLAY INPUT MODE
INPUT SELECTOR
A.F.D. MOVIE MUSIC
2
55 US