Before you perform Auto
Calibration
Before you perform the Auto Calibration, set
up and connect the speakers (page 14–16).
• The AUTO CAL MIC jack is used for the
supplied optimizer microphone only. Do not
connect other microphones to this jack.
Doing so may damage the receiver and the
microphone.
• During the measurement, the sound that
comes out of the speakers is very loud. The
volume of the sound cannot be adjusted. Pay
attention to the presence of children or to the
effect on your neighborhood.
• Perform the measurement in a quiet
environment to avoid the effect of noise and
get a more accurate measurement.
• If there are any obstacles in the path between
the optimizer microphone and the speakers,
the calibration cannot be performed
correctly. Remove any obstacles from the
measurement area to avoid measurement
error.
Note
The Auto Calibration function does not work in the
following cases.
– Headphones are connected
– SPEAKERS (OFF/A/B/A+B) is set to off.
Optimizer microphone
ON/STANDBY
POWER
MASTER VOLUME
TONE MODE
TUNING MODE
DISPLAY
INPUT MODE
MULTI CHANNEL DECODING
TONE
TUNING
INPUT SELECTOR
SPEAKERS
(OFF/A/B/A+B)
MEMORY/
2CH/
ENTER
DIMMER
A.DIRECT
A.F.D.
MOVIE
MUSIC
VIDEO 2 IN/PORTABLE AV IN
PHONES
VIDEO
L AUDIO R
AUTO CAL MIC
AUTO CAL MIC
US