6: Preparing The Receiver And The Remote - Sony STR-DG920 Operating Instructions Manual

6: Preparing the receiver
and the remote
Connecting the AC power cord
(mains lead)
Connect the AC power cord (mains lead) to a
wall outlet.
AC power cord (mains lead)
SURROUND BACK
R L
SURROUND
R L
FRONT B
R L
FRONT A
R L
SPEAKERS
Notes
• Before connecting the AC power cord (mains
lead), make sure that metallic wires of the speaker
cords are not touching each other between the
SPEAKERS terminals.
• Connect the AC power cord (mains lead) firmly.
CENTER
To the wall outlet
Performing initial setup
operations
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their factory defaults.
Be sure to use the buttons on the receiver for
this operation.
1,2
ON/STANDBY
POWER
TONE MODE TUNING MODE
MULTI CHANNEL DECODING
TONE TUNING
SPEAKERS
(OFF/A/B/A+B)
MEMORY/ 2CH/
ENTER DIMMER A.DIRECT
VIDEO 2 IN/PORTABLE AV IN
PHONES
VIDEO L AUDIO R AUTO CAL MIC
2,3 2,3
1
Press POWER to turn off the
receiver.
2
While holding down TONE
MODE and 2CH/A.DIRECT,
press POWER to turn on the
receiver.
3
Release the TONE MODE and
2CH/A.DIRECT after a few
seconds.
After "CLEARING" appears on the
display for a while, "CLEARED !"
appears.
All the settings you have changed or
adjusted are reset to the initial settings.
MASTER VOLUME
DISPLAY INPUT MODE
INPUT SELECTOR
A.F.D. MOVIE MUSIC
35 US