Honeywell CENTRA LINE EAGLEHAWK NX Installation & Commissioning Instructions page 13

EAGLEHAWK NX CONTROLLER – INSTALLATION & COMMISSIONING INSTRUCTIONS
5. Press 1 in the Main menu.
RESULT: The Network Setup displays.
6. Configure the network as desired by applying the available
options displayed.
7. To reset the controller to factory defaults, press F in the
Boot menu.
ATTENTION: Resetting the controller to its factory
defaults will result in the following:
• The station will be deleted.
• The platform credentials will be deleted.
• The IP settings will be reset to the factory defaults (see
section "Default IP Addresses of Ethernet Interfaces 1 and
2" on pg. 8).
RECOMMENDATION: Before leaving (closing) the terminal
program, go to "Network Setup" and
enter the desired IP settings.
8. Reset the controller by entering Y.
FINISHED!
13 EN1Z-1039GE51 R1218