Download  Print this page

Programming The Remote - Sony 3-289-204-12(1) Operating Instructions Manual

Sony multi channel av receiver operating instructions.
Hide thumbs

Advertisement

Table of Contents

Programming the remote

You can customize the remote to match the
components connected to your receiver. You
can even program the remote to control non-
Sony components and also Sony components
that the remote is normally unable to control.
The procedure below uses as an example a
case in which a VCR made by a company other
than Sony is connected to the VIDEO 1 IN
jacks on the receiver.
Before you begin, note that:
– You cannot change the settings of PHONO.
– The remote can control only components
that accept infrared wireless control signals.
Be sure to turn on the receiver
and point the remote towards
the receiver when performing
the following procedure.
1
THEATER
THEATER
SHIFT
SHIFT
1
1
VIDEO 1
VIDEO 1
4
4
2,3
DVD
DVD
7
7
MD/
MD/
TAPE
TAPE
-/--
-/--
PHONO
PHONO
CLEAR/>10
CLEAR/>10
XM
XM
2CH/
2CH/
A.DIRECT
A.DIRECT
1
Press AV ?/1 while pressing RM
SET UP.
The RM SET UP indicator slowly flashes.
120
US
TV
TV
AMP
AMP
2
2
3
3
BD
BD
VIDEO 2
VIDEO 2
5
5
6
6
SAT
SAT
TV
TV
8
8
9
9
SA-CD/
SA-CD/
TUNER
TUNER
CD
CD
0/10
0/10
ENT/MEM
ENT/MEM
MULTI IN
MULTI IN
DMPORT
DMPORT
SIRIUS
SIRIUS
A.F.D.
A.F.D.
MOVIE
MOVIE
MUSIC
MUSIC
2
Press the input button
(including TV) for the
component you want to control.
For example, if you are going to control a
CD player, press SA-CD/CD.
The RM SET UP and the SHIFT button
indicator light up.
If you press the button for a component of
which you cannot program the remote,
such as DMPORT, XM or SIRIUS, etc.,
the RM SET UP indicator keeps flashing.
3
Press the numeric buttons to
enter the numeric code (or one
of the codes if more than one
code exists) corresponding to
the component and the maker
of the component you want to
control.
See the tables on page 121–124 for
information on the numeric code(s).
Note
For a TV remote code value, only numbers in
the 500's are valid.
4
Press ENT/MEM.
Once the numeric code has been verified,
the RM SET UP indicator slowly flashes
twice and the remote automatically exits
the programming mode.
4
5
Repeat steps 1 to 4 to control
other components.
Notes
• The indicator turns off while a valid button is
pressed.
• In step 2, if you press TUNER, you can only
program the button to control a tuner (page 124).
• In step 2, if you want to change to other input, press
SHIFT and then press the new input buttons you
want.
• For the numeric codes, only the last three numbers
entered are valid.

Advertisement

Table of Contents

   Related Manuals for Sony 3-289-204-12(1)

Comments to this Manuals

Symbols: 0
Latest comments: