Controls; Remote Control - GE AHE08 Series Owner's Manual And Installation Instructions

Controls

Features and appearance will vary.
Lights beside the touch pads on the air conditioner control panel
indicate the selected settings.
1 2
Air Conditioner Controls
1. Power Pad
Turns air conditioner on and off. When turned on, the
display will show the room temperature.
2. Display
Shows the room temperature or time remaining on the
Delay timer. Shows the Set temperature while setting
the temperature in Cool, ECO or Heat modes.
be set in Cool, ECO or Heat mode.
4. Mode Pad
Eco mode.
5. Fan Speed Pad
In Cool, ECO or Heat
to Auto, High, Med or Low on the unit.
In Fan
or Low on the unit.
6. Delay Pad
Delay ON—When the air conditioner is off, it can be
set to automatically come on in 1 to 24 hours at its
previous mode and fan settings.
Delay OFF—When the air conditioner is on, it can be
set to automatically turn off in 1 to 24 hours.
How to set:
Press the Delay pad. Each touch of the Increase
intervals.
To review the remaining time on the Delay timer, press
pads to set a new time if desired.
To cancel the timer, press
set time is --.
4
3 4
_ +
Mode Cool Fan Eco
Speed Auto Low Med High
5
Fan, Cool, Heat, or
High, Med,
pads will set the timer in 1-hour
pad until the
8 7
Filter Sleep
Heat
Reset Mode
Delay
6
7.
The Sleep mode sets the unit to gradually change
settings over an 8 hour period to allow for some
increased energy efficiency during sleep hours.
The Sleep mode is available only in Cool, Heat and
Fan only settings.
Press the Sleep mode pad and its light will
illuminate. The fan indicator will stay at the same
pads
setting but the air conditioner will automatically
change the Fan speed to low in either Cool, Heat or
Fan only mode.
In Fan only mode, the fan will stay in the Low speed
setting for 8 hours. After 8 hours, the air conditioner
will resume the settings that were in place before the
Sleep mode pad was pressed.
In Cool mode, the fan will stay in the Low speed
setting for 8 hours from the time the Sleep mode
pad was pressed. The air conditioner will also
raise the set point 2°F in 30 minutes and 2°F more
in another 30 minutes where it will remain for the
resume the settings that were in place before the
Sleep mode pad was pressed.
In Heat mode, the fan will stay in the Low speed
setting for 8 hours from the time the Sleep mode
pad was pressed. The air conditioner will also
lower the set point 2°F in 30 minutes and 2°F more
in another 30 minutes where it will remain for the
resume the settings that were in place before the
Sleep mode pad was pressed.
While the unit is in Sleep mode, pressing any pad
will return it to the settings that were in place before
the Sleep mode pad was pressed.
8. Filter Reset Pad
This feature automatically notifies you that the air filter
must be cleaned. The indicator light will come on after
250 hours of operation. Clean the air filter (refer to
page 6), place it back in the front panel, and press the
Filter Reset pad. The light will go off.
1
ON/OFF
4 MODE
5
SPEED
6
DELAY
TEMP/TIME
3
TEMP/TIME

Remote Control

49-7838