Download Print this page

Installation - Black & Decker BWE15A Use & Care Book

Black & decker air conditioner user manual
Hide thumbs

Advertisement

Power Supply Cord
NOTE: Your air conditioner's
device may differ from the one
shown,
A. Test button
B. Reset button
This room air conditioner is equipped with a power supply cord
required by UL. This power supply cord contains state-of-the-art
electronics that sense current leakage. If the cord is crushed, the
electronics detect current leakage and power will be disconnected
in a fraction of a second.
Electrical
Shock Hazard
Plug into a grounded 3 prong outlet,
Do not remove ground prong,
Do not use an adapter,
Do not use an extension
cord.
Failure to follow these instructions can result in death,
fire, or electrical
shock.
To test your
power
supply
cord:
1. Plug power supply cord into a grounded 3 prong outlet.
2. Press RESET (on some devices, a green light will turn on).
3. Press TEST (listen for click; Reset button will trip, and on
some devices, a green light will turn off).
4. Press and release RESET (listen for click; Reset button wilt
latch, and on some devices, a green light will turn on). The
power supply cord is ready for operation.
NOTES:
The Reset button must be pushed in for proper operation.
The power supply cord must be replaced if it fails to trip when
the test button is pressed or fails to reset.
Do not use the power supply cord as an off/on switch.
A damaged power supply cord must be replaced with a new
power supply cord obtained from the product manufacturer
and must not be repaired.
The power supply cord contains no user serviceable parts.
Opening the tamper-resistant
case voids all warranty and
performance claims.
INSTALLATION
INSTRUCTIONS
Excessive Weight Hazard
Use two or more people to move and install
air conditioner.
Failure to do so can result in back or other injury,
Remove
Packaging
Materials
Remove and dispose of/recycle packaging materials. Remove tape
and glue residue from surfaces before turning on the air
conditioner. Rub a small amount d liquid dish soap over the
adhesive with your fingers. Wipe with warm water and dry.
Do not use sharp instruments,
rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your air conditioner.
Handle the air conditioner gently.
Prepare unit for installation
Unpack unit on the floor next to installation location.
1,
Remove two front attachment screws. Separate the outer case
from the front with a putty knife at the catch points designated by the
arrows.
2. Remove the screws on top of the outer case.
3. Using the basepan handle, slowly and evenly pull chassis out from
outer case.
NOTE: Cover putty knife blade with masking
tape to guard
against damage of the unit finish.
5

Hide quick links:

Advertisement

loading

  Related Content for Black & Decker BWE15A

This manual is also suitable for:

Bwe18aBwe25a