Black & Decker 641915-00 Instruction Manual page 16

641915-00,FSCP200 Compressor
PROBLEM
Air leak from Possible defect in safety
safety valve. valve.
Pressure reading
It is normal for "some"
on the regulated
pressure drop to occur.
pressure gauge
drops when an
accessory is
used.
Prolonged excessive use of
Compressor is
air.
not supplying
enough air to
operate Compressor is not large
accessories. enough for air requirement.
Hole in hose.
Air leaks.
Excessive Condensation in tank
"auto" starting
and stopping
3/14/06 7:31 AM Page 16
CORRECTION
CAUSE
Operate safety valve
manually by pulling on ring.
If valve still leaks, it should
be replaced.
If there is an excessive
amount of pressure drop
when the accessory is used,
adjust the regulator following
the instructions in the
"Description of Operation"
paragraph in the "Operation
Section.
NOTE: Adjust the regulated
pressure under flow
conditions (while accessory
is being used).
Decrease amount of air
usage.
Check the accessory air
requirement. If it is higher
than the SCFM or pressure
supplied by your air
compressor, you need a
larger compressor.
Check and replace if
required.
Tighten fittings.
Drain tank
16